Mounting holes for boards.
- CGS01 Sub Oscillator
- varies between runs
- CGS02 Wavetable
- varies between runs
- CGS03 Psycho LFO
-Board 2.1" by 2.0"
-Hole centers 1.8" by 1.7", inset 0.1" from the edges of the board
- CGS04
-Board 1.8" by 1.3"
-Two holes only along right edge, hole centers 0.9", inset 0.2" from the top, bottom and right edges of the board
- CGS05
- not panel mounting.
- CGS06 Burst Generator
-Board 2.0" by 3.9"
-Hole centers 1.7" by 3.6", inset 0.15" from the edges of the board
-Also needs switch hole. 1" from left, 0.7" from bottom, (or from top right, depending on which way up it is mounted)
- CGS07 Gate sequencer.
Here is a panel drilling guide for these boards. It gives the center for each panel hole. It is at 300dpi and will need scaling if printed at any other resolution.
- CGS08 V8 simulator
-Board 2.0" by 4.6"
-Hole centers 1.7" by 4.3", inset 0.15" from the edges of the board
- CGS09 VC Divider
-Board 2.0" by 4.0"
-Hole centers 1.7" by 3.7", inset 0.15" from the edges of the board
- CGS10 Mini keyboard
-Board 2.4" by 1.8"
-Hole centers 2.1" by 1.5", inset 0.15" from the edges of the board
- CGS13 Gated Comp
-Board 2.0" by 4.6"
-Hole centers 1.7" by 4.3", inset 0.15" from the edges of the board
- CGS24 Gate to Trig
-Board 2.0" by 1.3"
-Hole centers 1.7" by 1.0", inset 0.15" from the edges of the board
- CGS26 Analog Logic
-Board 2.0" by 4.7"
-Hole centers 1.7" by 4.4", inset 0.15" from the edges of the board
- CGS29 Wave Multiplier
-Board 2.0" by 6.0"
-Hole centers 1.7" by 5.7", inset 0.15" from the edges of the board
Article, art & design copyright 2001 by Ken Stone
Modular Synth Home Disclaimer
|